/*
   * Bitbanged MDIO support.
   *
   * Author: Scott Wood <scottwood@freescale.com>
   * Copyright (c) 2007 Freescale Semiconductor
   *
   * Based on CPM2 MDIO code which is:
   *
   * Copyright (c) 2003 Intracom S.A.
   *  by Pantelis Antoniou <panto@intracom.gr>
   *
   * 2005 (c) MontaVista Software, Inc.
   * Vitaly Bordug <vbordug@ru.mvista.com>
   *
   * This file is licensed under the terms of the GNU General Public License
   * version 2. This program is licensed "as is" without any warranty of any
   * kind, whether express or implied.
   */
  
  #include <linux/module.h>
  #include <linux/mdio-bitbang.h>

  #include <linux/types.h>
  #include <linux/delay.h>

  #define MDIO_READ 2
  #define MDIO_WRITE 1
  
  #define MDIO_C45 (1<<15)
  #define MDIO_C45_ADDR (MDIO_C45 | 0)
  #define MDIO_C45_READ (MDIO_C45 | 3)
  #define MDIO_C45_WRITE (MDIO_C45 | 1)

  
  #define MDIO_SETUP_TIME 10
  #define MDIO_HOLD_TIME 10
  
  /* Minimum MDC period is 400 ns, plus some margin for error.  MDIO_DELAY
   * is done twice per period.
   */
  #define MDIO_DELAY 250
  
  /* The PHY may take up to 300 ns to produce data, plus some margin
   * for error.
   */
  #define MDIO_READ_DELAY 350
  
  /* MDIO must already be configured as output. */
  static void mdiobb_send_bit(struct mdiobb_ctrl *ctrl, int val)
  {
  	const struct mdiobb_ops *ops = ctrl->ops;
  
  	ops->set_mdio_data(ctrl, val);
  	ndelay(MDIO_DELAY);
  	ops->set_mdc(ctrl, 1);
  	ndelay(MDIO_DELAY);
  	ops->set_mdc(ctrl, 0);
  }
  
  /* MDIO must already be configured as input. */
  static int mdiobb_get_bit(struct mdiobb_ctrl *ctrl)
  {
  	const struct mdiobb_ops *ops = ctrl->ops;
  
  	ndelay(MDIO_DELAY);
  	ops->set_mdc(ctrl, 1);
  	ndelay(MDIO_READ_DELAY);
  	ops->set_mdc(ctrl, 0);
  
  	return ops->get_mdio_data(ctrl);
  }
  
  /* MDIO must already be configured as output. */
  static void mdiobb_send_num(struct mdiobb_ctrl *ctrl, u16 val, int bits)
  {
  	int i;
  
  	for (i = bits - 1; i >= 0; i--)
  		mdiobb_send_bit(ctrl, (val >> i) & 1);
  }
  
  /* MDIO must already be configured as input. */
  static u16 mdiobb_get_num(struct mdiobb_ctrl *ctrl, int bits)
  {
  	int i;
  	u16 ret = 0;
  
  	for (i = bits - 1; i >= 0; i--) {
  		ret <<= 1;
  		ret |= mdiobb_get_bit(ctrl);
  	}
  
  	return ret;
  }
  
  /* Utility to send the preamble, address, and
   * register (common to read and write).
   */

  static void mdiobb_cmd(struct mdiobb_ctrl *ctrl, int op, u8 phy, u8 reg)

  {
  	const struct mdiobb_ops *ops = ctrl->ops;
  	int i;
  
  	ops->set_mdio_dir(ctrl, 1);
  
  	/*
  	 * Send a 32 bit preamble ('1's) with an extra '1' bit for good
  	 * measure.  The IEEE spec says this is a PHY optional
  	 * requirement.  The AMD 79C874 requires one after power up and
  	 * one after a MII communications error.  This means that we are
  	 * doing more preambles than we need, but it is safer and will be
  	 * much more robust.
  	 */
  
  	for (i = 0; i < 32; i++)
  		mdiobb_send_bit(ctrl, 1);

  	/* send the start bit (01) and the read opcode (10) or write (01).

  	   Clause 45 operation uses 00 for the start and 11, 10 for
  	   read/write */

  	mdiobb_send_bit(ctrl, 0);

  	if (op & MDIO_C45)
  		mdiobb_send_bit(ctrl, 0);
  	else
  		mdiobb_send_bit(ctrl, 1);
  	mdiobb_send_bit(ctrl, (op >> 1) & 1);
  	mdiobb_send_bit(ctrl, (op >> 0) & 1);

  
  	mdiobb_send_num(ctrl, phy, 5);
  	mdiobb_send_num(ctrl, reg, 5);
  }

  /* In clause 45 mode all commands are prefixed by MDIO_ADDR to specify the
     lower 16 bits of the 21 bit address. This transfer is done identically to a
     MDIO_WRITE except for a different code. To enable clause 45 mode or
     MII_ADDR_C45 into the address. Theoretically clause 45 and normal devices
     can exist on the same bus. Normal devices should ignore the MDIO_ADDR
     phase. */
  static int mdiobb_cmd_addr(struct mdiobb_ctrl *ctrl, int phy, u32 addr)
  {
  	unsigned int dev_addr = (addr >> 16) & 0x1F;
  	unsigned int reg = addr & 0xFFFF;
  	mdiobb_cmd(ctrl, MDIO_C45_ADDR, phy, dev_addr);
  
  	/* send the turnaround (10) */
  	mdiobb_send_bit(ctrl, 1);
  	mdiobb_send_bit(ctrl, 0);
  
  	mdiobb_send_num(ctrl, reg, 16);
  
  	ctrl->ops->set_mdio_dir(ctrl, 0);
  	mdiobb_get_bit(ctrl);
  
  	return dev_addr;
  }

  
  static int mdiobb_read(struct mii_bus *bus, int phy, int reg)
  {
  	struct mdiobb_ctrl *ctrl = bus->priv;
  	int ret, i;

  	if (reg & MII_ADDR_C45) {
  		reg = mdiobb_cmd_addr(ctrl, phy, reg);
  		mdiobb_cmd(ctrl, MDIO_C45_READ, phy, reg);
  	} else
  		mdiobb_cmd(ctrl, MDIO_READ, phy, reg);

  	ctrl->ops->set_mdio_dir(ctrl, 0);

  	/* check the turnaround bit: the PHY should be driving it to zero, if this
  	 * PHY is listed in phy_ignore_ta_mask as having broken TA, skip that
  	 */
  	if (mdiobb_get_bit(ctrl) != 0 &&
  	    !(bus->phy_ignore_ta_mask & (1 << phy))) {

  		/* PHY didn't drive TA low -- flush any bits it
  		 * may be trying to send.
  		 */
  		for (i = 0; i < 32; i++)
  			mdiobb_get_bit(ctrl);
  
  		return 0xffff;
  	}
  
  	ret = mdiobb_get_num(ctrl, 16);
  	mdiobb_get_bit(ctrl);
  	return ret;
  }
  
  static int mdiobb_write(struct mii_bus *bus, int phy, int reg, u16 val)
  {
  	struct mdiobb_ctrl *ctrl = bus->priv;

  	if (reg & MII_ADDR_C45) {
  		reg = mdiobb_cmd_addr(ctrl, phy, reg);
  		mdiobb_cmd(ctrl, MDIO_C45_WRITE, phy, reg);
  	} else
  		mdiobb_cmd(ctrl, MDIO_WRITE, phy, reg);

  
  	/* send the turnaround (10) */
  	mdiobb_send_bit(ctrl, 1);
  	mdiobb_send_bit(ctrl, 0);
  
  	mdiobb_send_num(ctrl, val, 16);
  
  	ctrl->ops->set_mdio_dir(ctrl, 0);
  	mdiobb_get_bit(ctrl);
  	return 0;
  }
  
  struct mii_bus *alloc_mdio_bitbang(struct mdiobb_ctrl *ctrl)
  {
  	struct mii_bus *bus;

  	bus = mdiobus_alloc();

  	if (!bus)
  		return NULL;
  
  	__module_get(ctrl->ops->owner);
  
  	bus->read = mdiobb_read;
  	bus->write = mdiobb_write;
  	bus->priv = ctrl;
  
  	return bus;
  }

  EXPORT_SYMBOL(alloc_mdio_bitbang);

  
  void free_mdio_bitbang(struct mii_bus *bus)
  {
  	struct mdiobb_ctrl *ctrl = bus->priv;
  
  	module_put(ctrl->ops->owner);

  	mdiobus_free(bus);

  }

  EXPORT_SYMBOL(free_mdio_bitbang);

  
  MODULE_LICENSE("GPL");