/*
   * Configuation settings for the Renesas Solutions AP-325RXA board
   *
   * Copyright (C) 2008 Renesas Solutions Corp.
   * Copyright (C) 2008 Nobuhiro Iwamatsu <iwamatsu.nobuhiro@renesas.com>
   *

   * SPDX-License-Identifier:	GPL-2.0+

   */
  
  #ifndef __AP325RXA_H
  #define __AP325RXA_H

  #define CONFIG_CPU_SH7723	1

  #define CONFIG_DISPLAY_BOARDINFO

  #undef  CONFIG_SHOW_BOOT_PROGRESS

  /* MEMORY */
  #define AP325RXA_SDRAM_BASE		(0x88000000)
  #define AP325RXA_FLASH_BASE_1		(0xA0000000)
  #define AP325RXA_FLASH_BANK_SIZE	(128 * 1024 * 1024)
  
  /* undef to save memory	*/

  /* Monitor Command Prompt */

  /* Buffer size for Console output */

  #define CONFIG_SYS_PBSIZE		256

  /* List of legal baudrate settings for this board */

  #define CONFIG_SYS_BAUDRATE_TABLE	{ 38400 }

  
  /* SCIF */

  #define CONFIG_SCIF_A		1 /* SH7723 has SCIF and SCIFA */
  #define CONFIG_CONS_SCIF5	1
  
  /* Suppress display of console information at boot */

  #define CONFIG_SYS_MEMTEST_START	(AP325RXA_SDRAM_BASE)
  #define CONFIG_SYS_MEMTEST_END		(CONFIG_SYS_MEMTEST_START + (60 * 1024 * 1024))

  
  /* Enable alternate, more extensive, memory test */

  #undef  CONFIG_SYS_ALT_MEMTEST

  /* Scratch address used by the alternate memory test */

  #undef  CONFIG_SYS_MEMTEST_SCRATCH

  
  /* Enable temporary baudrate change while serial download */

  #undef  CONFIG_SYS_LOADS_BAUD_CHANGE

  #define CONFIG_SYS_SDRAM_BASE	(AP325RXA_SDRAM_BASE)

  /* maybe more, but if so u-boot doesn't know about it... */

  #define CONFIG_SYS_SDRAM_SIZE	(128 * 1024 * 1024)

  /* default load address for scripts ?!? */

  #define CONFIG_SYS_LOAD_ADDR	(CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024)

  
  /* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */

  #define CONFIG_SYS_MONITOR_BASE	(AP325RXA_FLASH_BASE_1)

  /* Monitor size */

  #define CONFIG_SYS_MONITOR_LEN	(128 * 1024)

  /* Size of DRAM reserved for malloc() use */

  #define CONFIG_SYS_MALLOC_LEN	(256 * 1024)

  #define CONFIG_SYS_BOOTMAPSZ	(8 * 1024 * 1024)

  
  /* FLASH */
  #define CONFIG_FLASH_CFI_DRIVER 1

  #define CONFIG_SYS_FLASH_CFI
  #undef  CONFIG_SYS_FLASH_QUIET_TEST

  /* print 'E' for empty sector on flinfo */

  #define CONFIG_SYS_FLASH_EMPTY_INFO

  /* Physical start address of Flash memory */

  #define CONFIG_SYS_FLASH_BASE	(AP325RXA_FLASH_BASE_1)

  /* Max number of sectors on each Flash chip */

  #define CONFIG_SYS_MAX_FLASH_SECT	512

  
  /*
   * IDE support
   */
  #define CONFIG_IDE_RESET	1

  #define CONFIG_SYS_PIO_MODE		1
  #define CONFIG_SYS_IDE_MAXBUS		1	/* IDE bus */
  #define CONFIG_SYS_IDE_MAXDEVICE	1
  #define CONFIG_SYS_ATA_BASE_ADDR	0xB4180000
  #define CONFIG_SYS_ATA_STRIDE		2	/* 1bit shift */
  #define CONFIG_SYS_ATA_DATA_OFFSET	0x200	/* data reg offset */
  #define CONFIG_SYS_ATA_REG_OFFSET	0x200	/* reg offset */
  #define CONFIG_SYS_ATA_ALT_OFFSET	0x210	/* alternate register offset */

  #define CONFIG_IDE_SWAP_IO

  
  /* if you use all NOR Flash , you change dip-switch. Please see Manual. */

  #define CONFIG_SYS_MAX_FLASH_BANKS	1
  #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE + (0 * AP325RXA_FLASH_BANK_SIZE)}

  
  /* Timeout for Flash erase operations (in ms) */

  #define CONFIG_SYS_FLASH_ERASE_TOUT	(3 * 1000)

  /* Timeout for Flash write operations (in ms) */

  #define CONFIG_SYS_FLASH_WRITE_TOUT	(3 * 1000)

  /* Timeout for Flash set sector lock bit operations (in ms) */

  #define CONFIG_SYS_FLASH_LOCK_TOUT	(3 * 1000)

  /* Timeout for Flash clear lock bit operations (in ms) */

  #define CONFIG_SYS_FLASH_UNLOCK_TOUT	(3 * 1000)

  
  /*
   * Use hardware flash sectors protection instead
   * of U-Boot software protection
   */

  #undef  CONFIG_SYS_FLASH_PROTECTION
  #undef  CONFIG_SYS_DIRECT_FLASH_TFTP

  
  /* ENV setting */

  #define CONFIG_ENV_OVERWRITE	1

  #define CONFIG_ENV_SECT_SIZE	(128 * 1024)
  #define CONFIG_ENV_SIZE		(CONFIG_ENV_SECT_SIZE)

  #define CONFIG_ENV_ADDR		(CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN)
  /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */
  #define CONFIG_ENV_OFFSET		(CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE)

  #define CONFIG_ENV_SIZE_REDUND	(CONFIG_ENV_SECT_SIZE)

  
  /* Board Clock */
  #define CONFIG_SYS_CLK_FREQ	33333333

  #define CONFIG_SH_TMU_CLK_FREQ CONFIG_SYS_CLK_FREQ
  #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ

  #define CONFIG_SYS_TMU_CLK_DIV		(4)	/* 4 (default), 16, 64, 256 or 1024 */

  
  #endif	/* __AP325RXA_H */