14 Nov, 2008
1 commit
-
Make execve() take advantage of copy-on-write credentials, allowing it to set
up the credentials in advance, and then commit the whole lot after the point
of no return.This patch and the preceding patches have been tested with the LTP SELinux
testsuite.This patch makes several logical sets of alteration:
(1) execve().
The credential bits from struct linux_binprm are, for the most part,
replaced with a single credentials pointer (bprm->cred). This means that
all the creds can be calculated in advance and then applied at the point
of no return with no possibility of failure.I would like to replace bprm->cap_effective with:
cap_isclear(bprm->cap_effective)
but this seems impossible due to special behaviour for processes of pid 1
(they always retain their parent's capability masks where normally they'd
be changed - see cap_bprm_set_creds()).The following sequence of events now happens:
(a) At the start of do_execve, the current task's cred_exec_mutex is
locked to prevent PTRACE_ATTACH from obsoleting the calculation of
creds that we make.(a) prepare_exec_creds() is then called to make a copy of the current
task's credentials and prepare it. This copy is then assigned to
bprm->cred.This renders security_bprm_alloc() and security_bprm_free()
unnecessary, and so they've been removed.(b) The determination of unsafe execution is now performed immediately
after (a) rather than later on in the code. The result is stored in
bprm->unsafe for future reference.(c) prepare_binprm() is called, possibly multiple times.
(i) This applies the result of set[ug]id binaries to the new creds
attached to bprm->cred. Personality bit clearance is recorded,
but now deferred on the basis that the exec procedure may yet
fail.(ii) This then calls the new security_bprm_set_creds(). This should
calculate the new LSM and capability credentials into *bprm->cred.This folds together security_bprm_set() and parts of
security_bprm_apply_creds() (these two have been removed).
Anything that might fail must be done at this point.(iii) bprm->cred_prepared is set to 1.
bprm->cred_prepared is 0 on the first pass of the security
calculations, and 1 on all subsequent passes. This allows SELinux
in (ii) to base its calculations only on the initial script and
not on the interpreter.(d) flush_old_exec() is called to commit the task to execution. This
performs the following steps with regard to credentials:(i) Clear pdeath_signal and set dumpable on certain circumstances that
may not be covered by commit_creds().(ii) Clear any bits in current->personality that were deferred from
(c.i).(e) install_exec_creds() [compute_creds() as was] is called to install the
new credentials. This performs the following steps with regard to
credentials:(i) Calls security_bprm_committing_creds() to apply any security
requirements, such as flushing unauthorised files in SELinux, that
must be done before the credentials are changed.This is made up of bits of security_bprm_apply_creds() and
security_bprm_post_apply_creds(), both of which have been removed.
This function is not allowed to fail; anything that might fail
must have been done in (c.ii).(ii) Calls commit_creds() to apply the new credentials in a single
assignment (more or less). Possibly pdeath_signal and dumpable
should be part of struct creds.(iii) Unlocks the task's cred_replace_mutex, thus allowing
PTRACE_ATTACH to take place.(iv) Clears The bprm->cred pointer as the credentials it was holding
are now immutable.(v) Calls security_bprm_committed_creds() to apply any security
alterations that must be done after the creds have been changed.
SELinux uses this to flush signals and signal handlers.(f) If an error occurs before (d.i), bprm_free() will call abort_creds()
to destroy the proposed new credentials and will then unlock
cred_replace_mutex. No changes to the credentials will have been
made.(2) LSM interface.
A number of functions have been changed, added or removed:
(*) security_bprm_alloc(), ->bprm_alloc_security()
(*) security_bprm_free(), ->bprm_free_security()Removed in favour of preparing new credentials and modifying those.
(*) security_bprm_apply_creds(), ->bprm_apply_creds()
(*) security_bprm_post_apply_creds(), ->bprm_post_apply_creds()Removed; split between security_bprm_set_creds(),
security_bprm_committing_creds() and security_bprm_committed_creds().(*) security_bprm_set(), ->bprm_set_security()
Removed; folded into security_bprm_set_creds().
(*) security_bprm_set_creds(), ->bprm_set_creds()
New. The new credentials in bprm->creds should be checked and set up
as appropriate. bprm->cred_prepared is 0 on the first call, 1 on the
second and subsequent calls.(*) security_bprm_committing_creds(), ->bprm_committing_creds()
(*) security_bprm_committed_creds(), ->bprm_committed_creds()New. Apply the security effects of the new credentials. This
includes closing unauthorised files in SELinux. This function may not
fail. When the former is called, the creds haven't yet been applied
to the process; when the latter is called, they have.The former may access bprm->cred, the latter may not.
(3) SELinux.
SELinux has a number of changes, in addition to those to support the LSM
interface changes mentioned above:(a) The bprm_security_struct struct has been removed in favour of using
the credentials-under-construction approach.(c) flush_unauthorized_files() now takes a cred pointer and passes it on
to inode_has_perm(), file_has_perm() and dentry_open().Signed-off-by: David Howells
Acked-by: James Morris
Acked-by: Serge Hallyn
Signed-off-by: James Morris
14 Aug, 2008
1 commit
-
Fix the setting of PF_SUPERPRIV by __capable() as it could corrupt the flags
the target process if that is not the current process and it is trying to
change its own flags in a different way at the same time.__capable() is using neither atomic ops nor locking to protect t->flags. This
patch removes __capable() and introduces has_capability() that doesn't set
PF_SUPERPRIV on the process being queried.This patch further splits security_ptrace() in two:
(1) security_ptrace_may_access(). This passes judgement on whether one
process may access another only (PTRACE_MODE_ATTACH for ptrace() and
PTRACE_MODE_READ for /proc), and takes a pointer to the child process.
current is the parent.(2) security_ptrace_traceme(). This passes judgement on PTRACE_TRACEME only,
and takes only a pointer to the parent process. current is the child.In Smack and commoncap, this uses has_capability() to determine whether
the parent will be permitted to use PTRACE_ATTACH if normal checks fail.
This does not set PF_SUPERPRIV.Two of the instances of __capable() actually only act on current, and so have
been changed to calls to capable().Of the places that were using __capable():
(1) The OOM killer calls __capable() thrice when weighing the killability of a
process. All of these now use has_capability().(2) cap_ptrace() and smack_ptrace() were using __capable() to check to see
whether the parent was allowed to trace any process. As mentioned above,
these have been split. For PTRACE_ATTACH and /proc, capable() is now
used, and for PTRACE_TRACEME, has_capability() is used.(3) cap_safe_nice() only ever saw current, so now uses capable().
(4) smack_setprocattr() rejected accesses to tasks other than current just
after calling __capable(), so the order of these two tests have been
switched and capable() is used instead.(5) In smack_file_send_sigiotask(), we need to allow privileged processes to
receive SIGIO on files they're manipulating.(6) In smack_task_wait(), we let a process wait for a privileged process,
whether or not the process doing the waiting is privileged.I've tested this with the LTP SELinux and syscalls testscripts.
Signed-off-by: David Howells
Acked-by: Serge Hallyn
Acked-by: Casey Schaufler
Acked-by: Andrew G. Morgan
Acked-by: Al Viro
Signed-off-by: James Morris
14 Jul, 2008
1 commit
-
The register security hook is no longer required, as the capability
module is always registered. LSMs wishing to stack capability as
a secondary module should do so explicitly.Signed-off-by: James Morris
Acked-by: Stephen Smalley
Acked-by: Greg Kroah-Hartman
28 Apr, 2008
1 commit
-
With the introduction of per-process securebits, the capabilities-related
prctl callbacks were moved into cap_task_prctl(). Have root_plug use
cap_task_prctl() so that PR_SET_KEEPCAPS is defined.Signed-off-by: Serge E. Hallyn
Acked-by: Greg Kroah-Hartman
Signed-off-by: Andrew Morton
Signed-off-by: Linus Torvalds
18 Apr, 2008
1 commit
-
__FUNCTION__ is gcc-specific, use __func__
Signed-off-by: Harvey Harrison
Cc: James Morris
Cc: Stephen Smalley
Signed-off-by: Andrew Morton
Signed-off-by: James Morris
17 Oct, 2007
1 commit
-
Convert LSM into a static interface, as the ability to unload a security
module is not required by in-tree users and potentially complicates the
overall security architecture.Needlessly exported LSM symbols have been unexported, to help reduce API
abuse.Parameters for the capability and root_plug modules are now specified
at boot.The SECURITY_FRAMEWORK_VERSION macro has also been removed.
In a nutshell, there is no safe way to unload an LSM. The modular interface
is thus unecessary and broken infrastructure. It is used only by out-of-tree
modules, which are often binary-only, illegal, abusive of the API and
dangerous, e.g. silently re-vectoring SELinux.[akpm@linux-foundation.org: cleanups]
[akpm@linux-foundation.org: USB Kconfig fix]
[randy.dunlap@oracle.com: fix LSM kernel-doc]
Signed-off-by: James Morris
Acked-by: Chris Wright
Cc: Stephen Smalley
Cc: "Serge E. Hallyn"
Acked-by: Arjan van de Ven
Signed-off-by: Randy Dunlap
Signed-off-by: Andrew Morton
Signed-off-by: Linus Torvalds
01 Jul, 2006
1 commit
-
Signed-off-by: Jörn Engel
Signed-off-by: Adrian Bunk
17 Apr, 2005
1 commit
-
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.Let it rip!
