/*

   * Copyright (C) 2012-2014 Freescale Semiconductor, Inc.

   *

   * Configuration settings for the Freescale i.MX6Q SabreAuto board.

   *

   * SPDX-License-Identifier:	GPL-2.0+

   */
  
  #ifndef __MX6QSABREAUTO_CONFIG_H
  #define __MX6QSABREAUTO_CONFIG_H

  
  #define CONFIG_MACH_TYPE	3529
  #define CONFIG_MXC_UART_BASE	UART4_BASE

  #define CONFIG_CONSOLE_DEV		"ttymxc3"

  #define CONFIG_MMCROOT			"/dev/mmcblk2p2"  /* SDHC3 */

  #define CONFIG_SYS_USE_NAND
  
  #include "mx6sabre_common.h"
  #include <asm/imx-common/gpio.h>

  #undef CONFIG_MFG_NAND_PARTITION
  #ifdef CONFIG_SYS_BOOT_NAND

  #define CONFIG_MFG_NAND_PARTITION "mtdparts=8000000.nor:1m(boot),-(rootfs)\\\\;gpmi-nand:64m(boot),16m(kernel),16m(dtb),-(rootfs) "

  #else
  #define CONFIG_MFG_NAND_PARTITION ""
  #endif

  /*Since the pin conflicts on EIM D18, disable the USB host if the NOR flash is enabled */
  #if !defined(CONFIG_SYS_USE_SPINOR) && !defined(CONFIG_SYS_USE_EIMNOR)

  /* USB Configs */
  #define CONFIG_CMD_USB
  #define CONFIG_USB_EHCI
  #define CONFIG_USB_EHCI_MX6
  #define CONFIG_USB_STORAGE

  #define CONFIG_EHCI_HCD_INIT_AFTER_RESET

  #define CONFIG_USB_HOST_ETHER
  #define CONFIG_USB_ETHER_ASIX

  #define CONFIG_MXC_USB_PORTSC  (PORT_PTS_UTMI | PORT_PTS_PTW)
  #define CONFIG_MXC_USB_FLAGS   0
  #define CONFIG_USB_MAX_CONTROLLER_COUNT 2 /* Enabled USB controller number */
  
  /* MAX7310 configs*/
  #define CONFIG_MAX7310_IOEXP
  #define CONFIG_IOEXP_DEVICES_NUM 3
  #define CONFIG_IOEXP_DEV_PINS_NUM 8
  #endif

  #define CONFIG_SYS_FSL_USDHC_NUM	2

  #define CONFIG_SYS_MMC_ENV_DEV		1  /* SDHC3 */

  #define CONFIG_SYS_MMC_ENV_PART                0       /* user partition */

  #ifdef CONFIG_SYS_USE_SPINOR
  #define CONFIG_SF_DEFAULT_CS   (1|(IMX_GPIO_NR(3, 19)<<8))
  #endif

  #endif                         /* __MX6QSABREAUTO_CONFIG_H */