/* SPDX-License-Identifier: GPL-2.0+ */

  /*
   * Copyright 2016 Freescale Semiconductor

   * Copyright 2019 NXP

   */
  
  #ifndef __LS1046ARDB_H__
  #define __LS1046ARDB_H__
  
  #include "ls1046a_common.h"

  #define CONFIG_SYS_CLK_FREQ		100000000
  #define CONFIG_DDR_CLK_FREQ		100000000
  
  #define CONFIG_LAYERSCAPE_NS_ACCESS

  
  #define CONFIG_DIMM_SLOTS_PER_CTLR	1
  /* Physical Memory Map */
  #define CONFIG_CHIP_SELECTS_PER_CTRL	4

  
  #define CONFIG_DDR_SPD
  #define SPD_EEPROM_ADDRESS		0x51
  #define CONFIG_SYS_SPD_BUS_NUM		0
  
  #define CONFIG_DDR_ECC
  #define CONFIG_ECC_INIT_VIA_DDRCONTROLLER
  #define CONFIG_MEM_INIT_VALUE           0xdeadbeef

  #ifdef CONFIG_SD_BOOT

  #define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1046ardb/ls1046ardb_pbi.cfg

  #ifdef CONFIG_EMMC_BOOT
  #define CONFIG_SYS_FSL_PBL_RCW \
  	board/freescale/ls1046ardb/ls1046ardb_rcw_emmc.cfg
  #else
  #define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1046ardb/ls1046ardb_rcw_sd.cfg
  #endif

  #elif defined(CONFIG_QSPI_BOOT)
  #define CONFIG_SYS_FSL_PBL_RCW \
  	board/freescale/ls1046ardb/ls1046ardb_rcw_qspi.cfg
  #define CONFIG_SYS_FSL_PBL_PBI \
  	board/freescale/ls1046ardb/ls1046ardb_qspi_pbi.cfg
  #define CONFIG_SYS_UBOOT_BASE		0x40100000
  #define CONFIG_SYS_SPL_ARGS_ADDR	0x90000000

  #endif

  #ifndef SPL_NO_IFC

  /* IFC */
  #define CONFIG_FSL_IFC

  /*
   * NAND Flash Definitions
   */
  #define CONFIG_NAND_FSL_IFC

  #endif

  
  #define CONFIG_SYS_NAND_BASE		0x7e800000
  #define CONFIG_SYS_NAND_BASE_PHYS	CONFIG_SYS_NAND_BASE
  
  #define CONFIG_SYS_NAND_CSPR_EXT	(0x0)
  #define CONFIG_SYS_NAND_CSPR	(CSPR_PHYS_ADDR(CONFIG_SYS_NAND_BASE_PHYS) \
  				| CSPR_PORT_SIZE_8	\
  				| CSPR_MSEL_NAND	\
  				| CSPR_V)
  #define CONFIG_SYS_NAND_AMASK	IFC_AMASK(64 * 1024)
  #define CONFIG_SYS_NAND_CSOR	(CSOR_NAND_ECC_ENC_EN	/* ECC on encode */ \
  				| CSOR_NAND_ECC_DEC_EN	/* ECC on decode */ \
  				| CSOR_NAND_ECC_MODE_8	/* 8-bit ECC */ \
  				| CSOR_NAND_RAL_3	/* RAL = 3 Bytes */ \
  				| CSOR_NAND_PGS_4K	/* Page Size = 4K */ \
  				| CSOR_NAND_SPRZ_224	/* Spare size = 224 */ \
  				| CSOR_NAND_PB(64))	/* 64 Pages Per Block */
  
  #define CONFIG_SYS_NAND_ONFI_DETECTION
  
  #define CONFIG_SYS_NAND_FTIM0		(FTIM0_NAND_TCCST(0x7) | \
  					FTIM0_NAND_TWP(0x18)   | \
  					FTIM0_NAND_TWCHT(0x7) | \
  					FTIM0_NAND_TWH(0xa))
  #define CONFIG_SYS_NAND_FTIM1		(FTIM1_NAND_TADLE(0x32) | \
  					FTIM1_NAND_TWBE(0x39)  | \
  					FTIM1_NAND_TRR(0xe)   | \
  					FTIM1_NAND_TRP(0x18))
  #define CONFIG_SYS_NAND_FTIM2		(FTIM2_NAND_TRAD(0xf) | \
  					FTIM2_NAND_TREH(0xa) | \
  					FTIM2_NAND_TWHRE(0x1e))
  #define CONFIG_SYS_NAND_FTIM3		0x0
  
  #define CONFIG_SYS_NAND_BASE_LIST	{ CONFIG_SYS_NAND_BASE }
  #define CONFIG_SYS_MAX_NAND_DEVICE	1
  #define CONFIG_MTD_NAND_VERIFY_WRITE

  
  #define CONFIG_SYS_NAND_BLOCK_SIZE	(128 * 1024)
  
  /*
   * CPLD
   */
  #define CONFIG_SYS_CPLD_BASE		0x7fb00000
  #define CPLD_BASE_PHYS			CONFIG_SYS_CPLD_BASE
  
  #define CONFIG_SYS_CPLD_CSPR_EXT	(0x0)
  #define CONFIG_SYS_CPLD_CSPR		(CSPR_PHYS_ADDR(CPLD_BASE_PHYS) | \
  					CSPR_PORT_SIZE_8 | \
  					CSPR_MSEL_GPCM | \
  					CSPR_V)
  #define CONFIG_SYS_CPLD_AMASK		IFC_AMASK(64 * 1024)
  #define CONFIG_SYS_CPLD_CSOR		CSOR_NOR_ADM_SHIFT(16)
  
  /* CPLD Timing parameters for IFC GPCM */
  #define CONFIG_SYS_CPLD_FTIM0		(FTIM0_GPCM_TACSE(0x0e) | \
  					FTIM0_GPCM_TEADC(0x0e) | \
  					FTIM0_GPCM_TEAHC(0x0e))
  #define CONFIG_SYS_CPLD_FTIM1		(FTIM1_GPCM_TACO(0xff) | \
  					FTIM1_GPCM_TRAD(0x3f))
  #define CONFIG_SYS_CPLD_FTIM2		(FTIM2_GPCM_TCS(0xf) | \
  					FTIM2_GPCM_TCH(0xf) | \
  					FTIM2_GPCM_TWP(0x3E))
  #define CONFIG_SYS_CPLD_FTIM3		0x0
  
  /* IFC Timing Params */
  #define CONFIG_SYS_CSPR0_EXT		CONFIG_SYS_NAND_CSPR_EXT
  #define CONFIG_SYS_CSPR0		CONFIG_SYS_NAND_CSPR
  #define CONFIG_SYS_AMASK0		CONFIG_SYS_NAND_AMASK
  #define CONFIG_SYS_CSOR0		CONFIG_SYS_NAND_CSOR
  #define CONFIG_SYS_CS0_FTIM0		CONFIG_SYS_NAND_FTIM0
  #define CONFIG_SYS_CS0_FTIM1		CONFIG_SYS_NAND_FTIM1
  #define CONFIG_SYS_CS0_FTIM2		CONFIG_SYS_NAND_FTIM2
  #define CONFIG_SYS_CS0_FTIM3		CONFIG_SYS_NAND_FTIM3
  
  #define CONFIG_SYS_CSPR2_EXT		CONFIG_SYS_CPLD_CSPR_EXT
  #define CONFIG_SYS_CSPR2		CONFIG_SYS_CPLD_CSPR
  #define CONFIG_SYS_AMASK2		CONFIG_SYS_CPLD_AMASK
  #define CONFIG_SYS_CSOR2		CONFIG_SYS_CPLD_CSOR
  #define CONFIG_SYS_CS2_FTIM0		CONFIG_SYS_CPLD_FTIM0
  #define CONFIG_SYS_CS2_FTIM1		CONFIG_SYS_CPLD_FTIM1
  #define CONFIG_SYS_CS2_FTIM2		CONFIG_SYS_CPLD_FTIM2
  #define CONFIG_SYS_CS2_FTIM3		CONFIG_SYS_CPLD_FTIM3
  
  /* EEPROM */
  #define CONFIG_ID_EEPROM
  #define CONFIG_SYS_I2C_EEPROM_NXID
  #define CONFIG_SYS_EEPROM_BUS_NUM		0
  #define CONFIG_SYS_I2C_EEPROM_ADDR		0x53
  #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN		1
  #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS	3
  #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS	5
  #define I2C_RETIMER_ADDR			0x18

  /* PMIC */
  #define CONFIG_POWER
  #ifdef CONFIG_POWER
  #define CONFIG_POWER_I2C
  #endif

  /*
   * Environment
   */

  #ifndef SPL_NO_ENV

  #define CONFIG_ENV_OVERWRITE

  #endif

  #ifdef CONFIG_TFABOOT
  #define CONFIG_SYS_MMC_ENV_DEV		0

  #define CONFIG_SYS_FSL_QSPI_BASE        0x40000000

  #else

  #if defined(CONFIG_SD_BOOT)

  #define CONFIG_SYS_MMC_ENV_DEV		0

  #endif

  #endif

  #define AQR105_IRQ_MASK			0x80000000

  /* FMan */

  #ifndef SPL_NO_FMAN

  
  #ifdef CONFIG_NET

  #define CONFIG_PHY_REALTEK

  #endif

  #ifdef CONFIG_SYS_DPAA_FMAN

  #define RGMII_PHY1_ADDR			0x1
  #define RGMII_PHY2_ADDR			0x2
  
  #define SGMII_PHY1_ADDR			0x3
  #define SGMII_PHY2_ADDR			0x4
  
  #define FM1_10GEC1_PHY_ADDR		0x0

  #define FDT_SEQ_MACADDR_FROM_ENV

  #define CONFIG_ETHPRIME			"FM1@DTSEC3"
  #endif

  #endif

  
  /* QSPI device */

  #ifndef SPL_NO_QSPI

  #ifdef CONFIG_FSL_QSPI
  #define CONFIG_SPI_FLASH_SPANSION
  #define FSL_QSPI_FLASH_SIZE		(1 << 26)
  #define FSL_QSPI_FLASH_NUM		2

  #endif

  #endif

  #ifndef SPL_NO_MISC

  #undef CONFIG_BOOTCOMMAND

  #ifdef CONFIG_TFABOOT
  #define QSPI_NOR_BOOTCOMMAND "run distro_bootcmd; run qspi_bootcmd; "	\
  			   "env exists secureboot && esbc_halt;;"
  #define SD_BOOTCOMMAND "run distro_bootcmd;run sd_bootcmd; "	\
  			   "env exists secureboot && esbc_halt;"
  #else

  #if defined(CONFIG_QSPI_BOOT)

  #define CONFIG_BOOTCOMMAND "run distro_bootcmd; run qspi_bootcmd; "	\
  			   "env exists secureboot && esbc_halt;;"

  #elif defined(CONFIG_SD_BOOT)

  #define CONFIG_BOOTCOMMAND "run distro_bootcmd;run sd_bootcmd; "	\
  			   "env exists secureboot && esbc_halt;"

  #endif

  #endif

  #endif

  #include <asm/fsl_secure_boot.h>

  #endif /* __LS1046ARDB_H__ */