init.S
2.41 KB
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
/*
* (C) Copyright 2010
* Stefan Roese, DENX Software Engineering, sr@denx.de.
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <asm-offsets.h>
#include <ppc_asm.tmpl>
#include <config.h>
#include <asm/mmu.h>
/*
* TLB TABLE
*
* This table is used by the cpu boot code to setup the initial tlb
* entries. Rather than make broad assumptions in the cpu source tree,
* this table lets each board set things up however they like.
*
* Pointer to the table is returned in r1
*
*/
.section .bootpg,"ax"
.globl tlbtab
tlbtab:
tlbtab_start
/*
* BOOT_CS (FLASH) must be first. Before relocation SA_I can be off to
* use the speed up boot process. It is patched after relocation to
* enable SA_I
*/
tlbentry(CONFIG_SYS_BOOT_BASE_ADDR, SZ_16M,
CONFIG_SYS_BOOT_BASE_ADDR, 4, AC_RWX | SA_G)
/*
* TLB entries for SDRAM are not needed on this platform.
* They are dynamically generated in the DDR(2) detection
* routine.
*/
#ifdef CONFIG_SYS_INIT_RAM_DCACHE
/* TLB-entry for init-ram in dcache (SA_I must be turned off!) */
tlbentry(CONFIG_SYS_INIT_RAM_ADDR, SZ_4K, CONFIG_SYS_INIT_RAM_ADDR, 0,
AC_RWX | SA_G)
#endif
tlbentry(CONFIG_SYS_PCI_BASE, SZ_256M, 0x00000000, 0xc,
AC_RW | SA_IG)
tlbentry(CONFIG_SYS_PCI_MEMBASE, SZ_256M, 0x20000000, 0xc,
AC_RW | SA_IG)
tlbentry(CONFIG_SYS_PCIE_MEMBASE, SZ_256M, 0xB0000000, 0xd,
AC_RW | SA_IG)
tlbentry(CONFIG_SYS_PCIE0_CFGBASE, SZ_16M, 0x00000000, 0xd,
AC_RW | SA_IG)
tlbentry(CONFIG_SYS_PCIE1_CFGBASE, SZ_16M, 0x20000000, 0xd,
AC_RW | SA_IG)
tlbentry(CONFIG_SYS_PCIE0_XCFGBASE, SZ_1K, 0x10000000, 0xd,
AC_RW | SA_IG)
tlbentry(CONFIG_SYS_PCIE1_XCFGBASE, SZ_1K, 0x30000000, 0xd,
AC_RW | SA_IG)
/* PCIe UTL register */
tlbentry(CONFIG_SYS_PCIE_BASE, SZ_16K, 0x08010000, 0xc, AC_RW | SA_IG)
/* TLB-entry for FPGA(s) */
tlbentry(CONFIG_SYS_FPGA1_BASE, SZ_16M, CONFIG_SYS_FPGA1_BASE, 4,
AC_RW | SA_IG)
tlbentry(CONFIG_SYS_FPGA1_BASE + (16 << 20), SZ_16M,
CONFIG_SYS_FPGA1_BASE + (16 << 20), 4, AC_RW | SA_IG)
tlbentry(CONFIG_SYS_FPGA2_BASE, SZ_16M, CONFIG_SYS_FPGA2_BASE, 4,
AC_RW | SA_IG)
tlbentry(CONFIG_SYS_FPGA3_BASE, SZ_16M, CONFIG_SYS_FPGA3_BASE, 4,
AC_RW | SA_IG)
/* TLB-entry for OCM */
tlbentry(CONFIG_SYS_OCM_BASE, SZ_1M, 0x00000000, 4,
AC_RWX | SA_I)
/* TLB-entry for Local Configuration registers => peripherals */
tlbentry(CONFIG_SYS_LOCAL_CONF_REGS, SZ_16M,
CONFIG_SYS_LOCAL_CONF_REGS, 4, AC_RWX | SA_IG)
tlbtab_end