atngw100mkii.c 3 KB
/*
 * Copyright (C) 2010 Atmel Corporation
 *
 * Copyright (C) 2012 Andreas Bießmann <andreas@biessmann.org>
 *
 * SPDX-License-Identifier:	GPL-2.0+
 */
#include <common.h>

#include <spi.h>
#include <netdev.h>

#include <asm/io.h>
#include <asm/sdram.h>
#include <asm/arch/clk.h>
#include <asm/arch/gpio.h>
#include <asm/arch/hmatrix.h>
#include <asm/arch/mmu.h>
#include <asm/arch/portmux.h>

DECLARE_GLOBAL_DATA_PTR;

struct mmu_vm_range mmu_vmr_table[CONFIG_SYS_NR_VM_REGIONS] = {
	{
		/* Atmel AT49BV640D 8 MiB x16 NOR flash on NCS0 */
		.virt_pgno	= CONFIG_SYS_FLASH_BASE >> MMU_PAGE_SHIFT,
		.nr_pages	= CONFIG_SYS_FLASH_SIZE >> MMU_PAGE_SHIFT,
		.phys		= (CONFIG_SYS_FLASH_BASE >> MMU_PAGE_SHIFT)
					| MMU_VMR_CACHE_NONE,
	}, {
		/* Micron MT29F2G16AAD 256 MiB x16 NAND flash on NCS3 */
		.virt_pgno	= EBI_SRAM_CS3_BASE >> MMU_PAGE_SHIFT,
		.nr_pages	= EBI_SRAM_CS3_SIZE >> MMU_PAGE_SHIFT,
		.phys		= (EBI_SRAM_CS3_BASE >> MMU_PAGE_SHIFT)
					| MMU_VMR_CACHE_NONE,
	}, {
		/* 2x16-bit ISSI IS42S16320B 64 MiB SDRAM (128 MiB total) */
		.virt_pgno	= CONFIG_SYS_SDRAM_BASE >> MMU_PAGE_SHIFT,
		.nr_pages	= EBI_SDRAM_SIZE >> MMU_PAGE_SHIFT,
		.phys		= (CONFIG_SYS_SDRAM_BASE >> MMU_PAGE_SHIFT)
					| MMU_VMR_CACHE_WRBACK,
	},
};

static const struct sdram_config sdram_config = {
	.data_bits	= SDRAM_DATA_32BIT,
	.row_bits	= 13,
	.col_bits	= 10,
	.bank_bits	= 2,
	.cas		= 3,
	.twr		= 2,
	.trc		= 7,
	.trp		= 2,
	.trcd		= 2,
	.tras		= 5,
	.txsr		= 6,
	/* 7.81 us */
	.refresh_period	= (781 * (SDRAMC_BUS_HZ / 1000)) / 100000,
};

int board_early_init_f(void)
{
	/* Enable SDRAM in the EBI mux */
	hmatrix_slave_write(EBI, SFR, HMATRIX_BIT(EBI_SDRAM_ENABLE)
			| HMATRIX_BIT(EBI_NAND_ENABLE));

	portmux_enable_ebi(32, 23, PORTMUX_EBI_NAND,
			PORTMUX_DRIVE_HIGH);
	portmux_select_gpio(PORTMUX_PORT_E, 1 << 23,
			PORTMUX_DIR_OUTPUT | PORTMUX_INIT_HIGH
			| PORTMUX_DRIVE_MIN);

	sdram_init(uncached(EBI_SDRAM_BASE), &sdram_config);

	portmux_enable_usart1(PORTMUX_DRIVE_MIN);

#if defined(CONFIG_MACB)
	portmux_enable_macb0(PORTMUX_MACB_MII, PORTMUX_DRIVE_HIGH);
	portmux_enable_macb1(PORTMUX_MACB_MII, PORTMUX_DRIVE_HIGH);
#endif
#if defined(CONFIG_MMC)
	portmux_enable_mmci(0, PORTMUX_MMCI_4BIT, PORTMUX_DRIVE_LOW);
#endif
#if defined(CONFIG_ATMEL_SPI)
	portmux_enable_spi0(1 << 0, PORTMUX_DRIVE_LOW);
#endif

	return 0;
}

int board_early_init_r(void)
{
	gd->bd->bi_phy_id[0] = 0x01;
	gd->bd->bi_phy_id[1] = 0x03;
	return 0;
}

#ifdef CONFIG_CMD_NET
int board_eth_init(bd_t *bi)
{
	macb_eth_initialize(0, (void *)ATMEL_BASE_MACB0, bi->bi_phy_id[0]);
	macb_eth_initialize(1, (void *)ATMEL_BASE_MACB1, bi->bi_phy_id[1]);
	return 0;
}
#endif

/* SPI chip select control */
#ifdef CONFIG_ATMEL_SPI
#define ATNGW100_DATAFLASH_CS_PIN	GPIO_PIN_PA(3)

int spi_cs_is_valid(unsigned int bus, unsigned int cs)
{
	return bus == 0 && cs == 0;
}

void spi_cs_activate(struct spi_slave *slave)
{
	gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 0);
}

void spi_cs_deactivate(struct spi_slave *slave)
{
	gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 1);
}
#endif /* CONFIG_ATMEL_SPI */