Eric Lee / smarc-uboot

08 Feb, 2019

1 commit

19 Jan, 2019

1 commit

  • 29d280c88   sunxi: usb: Switch to Generic host controllers ... Browse Code »

    Onc of key blocker for using USB Generic host controller
    drivers in Allwinner are CLK and RESET drivers, now these
    available for USB usage.

    So switch sunxi USB use EHCI and OHCI Generic controllers.

    Enabling USB is wisely a board choise, So Enable USB_OHCI_HCD
    where it already have USB_EHCI_HCD

    Signed-off-by: Jagan Teki
    Acked-by: Maxime Ripard

    Jagan Teki
     

04 Sep, 2018

1 commit

17 Aug, 2018

1 commit

  • 86cf1c828   configs: Migrate CONFIG_NR_DRAM_BANKS ... Browse Code »
    13

    We have the following cases:
    - CONFIG_NR_DRAM_BANKS was defined, migrate normally
    - CONFIG_NR_DRAM_BANKS_MAX was defined and then used for
    CONFIG_NR_DRAM_BANKS after a check, just migrate it over now.
    - CONFIG_NR_DRAM_BANKS was very oddly defined on p2771-0000-* (to 1024 +
    2), set this to 8.

    Signed-off-by: Tom Rini

    Tom Rini
     

17 Jul, 2018

1 commit

  • 32f67bb7a   sunxi: Enable eMMC on Libre Computer Board ALL-H3-CC boards ... Browse Code »

    The Libretech ALL-H3-CC has a high density connector for attaching
    an eMMC module. The module form factor and connection is specific
    to Libretech, and has provisions for split vmmc/vqmmc (core and I/O)
    voltage supplies, but this board does not wire the vqmmc side. The
    H2+/H3/H5 SoCs do not support alternate I/O voltages for eMMC either.
    Only 3.3V is supported. A specific module that ties vqmmc to vmmc,
    with both at 3.3V, must be used.

    Given that a) eMMC is not designed to be hotplugged, b) power is
    always provided on the pins, and c) MMC controllers can deal with
    missing cards, we can enable this by default. If a module is attached
    it will be picked up by the system.

    The device tree change was also submitted to the Linux Kernel and
    has already been queued up for 4.19.

    Signed-off-by: Chen-Yu Tsai
    Acked-by: Maxime Ripard
    Reviewed-by: Jagan Teki

    Chen-Yu Tsai
     

01 May, 2018

1 commit

  • e9392b373   sunxi: Add Libre Computer Board ALL-H3-CC H5 ver. ... Browse Code »

    This patch adds a device tree file for the H5 version of the Libre
    Computer Board ALL-H3-CC. It is the same board first introduced in
    commit afe27544125e ("sunxi: Add support for Libre Computer Board
    ALL-H3-CC H3 ver."), with the H3 SoC replaced with the H5 SoC, and
    has 4Gb DDR3 chips instead of 2Gb ones.

    The device tree utilizes the common board design file for ALL-H3-CC,
    providing just the model strings and SoC specifics.

    Signed-off-by: Chen-Yu Tsai
    Acked-by: Maxime Ripard
    Reviewed-by: Jagan Teki

    Chen-Yu Tsai