09 Mar, 2008
12 commits
-
Update CHANGELOG for release.
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Wolfgang Denk -
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD
-
Signed-off-by: Wolfgang Denk
-
and get rid of a couple of unneeded casts.
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Wolfgang Denk
-
and simplify Makefile a bit.
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD
08 Mar, 2008
7 commits
-
When rtl_recv() of rtl8169 is called, OWNbit of status register
is not enable occasionally.
rtl_recv() doesn't work normally when the driver doesn't do
appropriate processing.
This patch fix this problem.Signed-off-by: Nobuhiro Iwamatsu
-
initialize the UPIOx controller.
Signed-off-by: Heiko Schocher
-
add support for the config Flash.
initialize the UPIOx controller.Signed-off-by: Heiko Schocher
-
the dts file basenames were updated in linux - this helps avoid
inadvertently loading any old dtbs laying around.Signed-off-by: Kim Phillips
-
allow u-boot to recover (and, e.g., switch to another interface) in the
case where a PHY does not report autonegotiation is complete within its
two second timeout value.Signed-off-by: Kim Phillips
07 Mar, 2008
5 commits
-
The taihu board used gpio_read_out_bit which reads the output register and not
the pin state.Signed-off-by: Markus Brunner
-
Signed-off-by: Stefan Roese
-
1. Make the CSB bus pipeline depth as 4, and enable
the repeat mode;
2. Raise the eTSEC emergency priority;
3. Use the highest IP blocks clock.Signed-off-by: Dave Liu
-
The latter version stops when "run load" fails for whatever reasons
rendering the combination *a lot* more secure.Signed-off-by: Detlev Zundel
06 Mar, 2008
1 commit
05 Mar, 2008
6 commits
-
This patch fixes a problem seen on PPC4xx boards, when no MAC address is
defined. Then no ethernet interface is available but a simple "tftp"
command will return without any error message which is quite confusing.Signed-off-by: Stefan Roese
-
Many of the spd.h #includers don't need it,
and wanted to have spd_sdram() declared instead.
Since they didn't get that, some also had open
coded extern declarations of it instead or as well.
Fix it all up by using spd_sdram.h where needed.Signed-off-by: Jon Loeliger
-
Signed-off-by: Wolfgang Denk
-
This patch fixes a problem seen on PPC4xx boards, when no MAC address is
defined. Then no ethernet interface is available but a simple "tftp"
command will return without any error message which is quite confusing.Signed-off-by: Stefan Roese
-
Signed-off-by: Wolfgang Denk
04 Mar, 2008
6 commits
-
Commit 5013c09f (Makefile: cleanup "clean" target) introduced a
problem for out-of-tree builds which caused "make clean" to fail.Signed-off-by: Wolfgang Denk
-
Signed-off-by: Wolfgang Denk
-
Every now and then a Sequoia board (or equivalent hardware) had
problems connecting to a Gigabit capable network interface.There were differences in the PHY setup between Linux and U-Boot.
This patch fixes the problem. Apparently "remote fault" is being set,
which signals to some devices (on the other end of the cable) that a
fault has occurred, while other devices ignore it. I believe the RF bit
was causing the issue, but I removed T4 also, to match up with Linux.Signed-off-by: Mike Nuss
-
Fix a typo in qe_upload_firmware() that prevented uploading firmware on
systems with more than one RISC core.Signed-off-by: Timur Tabi
-
Originally pointed out by Laurent Pinchart ,
see http://thread.gmane.org/gmane.comp.boot-loaders.u-boot/22846Signed-off-by: Bernhard Nemec ganssloser.com>
-
If I try to "cp.b ", u-boot selects normal flash
routines instead of dataflash. This is because it checks "if source
address is not dataflash" instead of target address.Signed-off-by: Kim B. Heino
03 Mar, 2008
3 commits
-
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Wolfgang Denk
-
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD